Quick Start

This page is for first-time users. It does not replace the full documentation, but helps you quickly understand the overall flow, prepare your checklist, and note key cautions.

Applicable Models

The current 3D-printed structure and installation plan are for Bambu Lab P2S / P1S. Other enclosed models can follow this flow, but you will need to design your own enclosure or riser structure.

What You Need to Prepare

• A 3D printer (for printing the riser and module parts).
• Basic soldering tools: soldering iron, solder, flux, tweezers, desoldering pump or wick.
• Basic assembly tools: Phillips screwdriver, needle-nose pliers, wire cutters, wire strippers.
• Basic measurement tools: multimeter (for short and polarity checks).
• A computer and USB-C data cable (for firmware flashing).

Process Overview

1. Read the project overview and features: Introduction
2. Download hardware and 3D model files: Hardware Source Files, 3D Models
3. Purchase materials: BOM
4. PCB fabrication: PCB Fabrication
5. 3D print and assemble the main frame: Main Frame Installation
6. Assemble modules (main controller, exhaust, power, etc.): Module – Main Controller
7. Solder and wire hardware: Assembly Instructions, Hardware Wiring Diagram
8. Download and flash firmware: Firmware Download, Firmware Flashing
9. Activation and first configuration: Firmware Activation, Function Description

First Power-On Checklist

• Confirm 24V power polarity is correct.
• Confirm the 12V/24V selection pads on the main control board are not shorted.
• Confirm fan and LED polarity is correct.
• Confirm the heater plate and MOSFET heatsinks are installed.
• Confirm all connectors are fully seated and not loose.
• Power with USB only for flashing and basic tests, then connect 24V power.